NAME

quotacheck — file system quota consistency checker

SYNOPSIS

DESCRIPTION

The quotacheck utility examines each file system, builds a table of current disk usage, and compares this table against that recorded in the disk quota file for the file system. If any inconsistencies are detected, both the quota file and the current system copy of the incorrect quotas are updated (the latter only occurs if an active file system is checked). By default both user and group quotas are checked.

The following options are available:

-a

If supplied in place of any file system names, quotacheck will check all the file systems indicated in /etc/fstab to be read-write with disk quotas. By default only the types of quotas listed in /etc/fstab are checked.

-c 32 | 64

Before performing its checks, quotacheck will convert the quota file to the specified word size. A conversion size of 64 is given to request conversion to the new 64-bit quota file format. A conversion size of 32 is given to request conversion back to the old 32-bit quota file format. The original quota file is left unchanged and moved aside with an underscore and its format size plus a .orig extension added to its name. Thus, the original 32-bit quota.user quota file converted to the 64-bit format quota file will be renamed to quota.user_32.orig.

-g

Only group quotas listed in /etc/fstab are to be checked.

-l maxrun

Specifies the maximum number of concurrent file systems to check in parallel. If this option is omitted, or if maxrun is zero, parallel passes are run as per fsck(8). This option is deprecated and parallel passes are always run as per fsck(8).

-u

Only user quotas listed in /etc/fstab are to be checked.

-v

Report discrepancies between the calculated and recorded disk quotas and other additional diagnostic messages.

Specifying both -g and -u is equivalent to the default. Parallel passes are run on the file systems required, using the pass numbers in /etc/fstab in an identical fashion to fsck(8).

Normally, quotacheck operates silently.

The quotacheck utility expects each file system to be checked to have a quota files named quota.user and quota.group which are located at the root of the associated file system. These defaults may be overridden in /etc/fstab. If a file is not present, quotacheck will create it. These files should be edited with the edquota(8) utility.

The quotacheck utility is normally run at boot time from the /etc/rc file. The rc startup procedure is controlled by the /etc/rc.conf variable check_quotas. Note that to enable this functionality in /etc/rc you also need to enable startup quota procedures with the variable enable_quotas in /etc/rc.conf. The kernel must also be built with options QUOTA.

The quotacheck utility accesses the raw device in calculating the actual disk usage for each user. Thus, the file systems checked should be quiescent while quotacheck is running.

FILES

quota.user

at the file system root with user quotas

quota.group

at the file system root with group quotas

/etc/fstab

default file systems

SEE ALSO

quota(1), quotactl(2), fstab(5), rc.conf(5), edquota(8), fsck(8), quotaon(8), repquota(8)

HISTORY

The quotacheck utility appeared in 4.2BSD.

BUGS

The quota system will ignore UIDs or GIDs that would be negative when evaluated as a signed value. Typically those types of ids can appear in the file system from NFS mounts or archive files from other operating systems. Extremely large UIDs or GIDs will cause quotacheck to run for an unreasonable amount of time and also produce extremely large quota data files.